GP Switch sensor (Quickshifter-only):
The Woolich Racing Quickshifter GP Switch detects gear shifts and momentarily cuts the engine. The Quickshifter GP Switch model does not distinguish between up-shifts and down-shifts so it only used as a Quickshifter for shifting up through the gears. The Quickshifter GP Switch does not work as an Autoblipper.
This method enables you to choose between bikes with a normal shift pattern and those with a reverse (race) shift pattern.
- Turn the ignition off so that the Quickshifter is powered off
- Hold down both buttons on the Quickshifter module
- While holding both buttons down, turn the ignition on
- The LED's will first show some numbers (firmware version) and will then show the letters “UP” as shown in the image below
- Release the two buttons and the letters 'UP' will flash indicating that the unit is ready to read the shift direction
- Apply and hold pressure on the Gear Shift lever in the upshift direction e.g. if the bike is in 2nd gear, apply pressure in the direction of 3rd gear, hold the pressure until the small LED dot blinks once and the LED display then turns off
- The Quickshifter should now be configured for the correct “UP” shift direction.
- You can test the activation by applying pressure to the gear shift lever, a small dot on the Quickshifter LED display will light up when the pressure applied initiates a shift.
ASG Sensor (Quickshifter and Autoblipper):
For all models using the ASG sensor you either can set the shift direction directly in the software, or you can set it manually through the sensor. You only need to complete this using ONE of these methods.
Method A: Changing the setting in the bin file
You can set the shift direction in the Race Tools section of the bin file. For some models you may find this in the 'Advanced Settings' instead. This method requires you to write to the ECU.
Method B: Manual Shift direction instructions
This complete procedure from 3 to 6 needs to be completed within 15 seconds, otherwise the configuration will be interrupted and the set up needs to be done again. This method does not require you to write to the ECU.
IMPORTANT. This procedure shall only be done with the ignition switched ON, engine NOT running.
1. Install the Quickshifter.
2. Switch on the ignition of the bike. Do not start the engine.
3. The LED flash 1 or 2 times depending on which shift direction is set.
4. Directly after the LED go out, push and hold the gear lever in the direction you want the Shift
direction until the LED flashes rapidly. This indicates that the Quickshifter is in ‘Configuration Mode’ for setting up the Up Shift direction.
5. Push the gear lever at least 5 times in a ‘pulse’ movement in the same direction as in step 3, the
Shift direction.
6. Directly after step 5, push and hold the gear lever in the same direction for 3 seconds. The LED will
go out, and then flash 1 or 2 times depending on which shift direction is set.
The Upshift direction is now set.
These Support Center articles may also be of interest to you: